I finally got my b20b from hmotors. I was going over the motor and swapping parts noticed a few things 1st there is no crank sensor by the crank and wanted to know if is was post to b there or if it is in the distributor. 2nd) The stock mount (b20) mount thats on the side of the block near the timing belt its the same as my 99 ls mount but the b20 mount is taller and the ls is shorter which one do i use? 3rd I have 2 intake air tempter sensors one in the intake tube thats stock for my 2000 civic and one in the 99 integra ls intake manifold which one do i use. I dont think that my harness will plug into the intake manifold. Everthing im putting on this motor is from a 99 integra ls. If the crank sensor is in the distributor will the 99 ls ecu throw that code even if the crank sensor is in the distributor. Thanks for the help

1) I don't think JDM B20's had crank position sensors, use the one from your integra motor.
2) Use the driver's side mount from the integra if it is going into an integra.
3) You can use either IAT

I'm going to take the side timing belt covers off and see if it will work. I'm putting the motor in a 2000 civic dx so will I still use the integra mount thanks for the help