I wanna know if this tool is sufficient enough to remove it or is there anything else you guys recomend

http://www.amazon.com/Alltrade-648796-C ... 80-6036722

That looks like an effective tool. I've seen/used ones that were integrated with a handle but i suppose this "socket" would work just as well. That and I think this is less expensive. Get a quality breaker bar to go with it (or two) and you should be golden.

bough it should be here the 22nd, how about holding the flywheel im place that ring gear holder is expnsive any other alternatives

Why would you need to hold the flywheel in place? That tool you are buying will hold it from the hex cut into the crank pully. Just slip in a 19mm or whatever it is onto the crank pully bolt and pull hard with a breaker bar on both sockets. Thats all you should have to do.

snap-on makes that same tool

My friend just bought one but it is one big wrench and The end looks just like that.